abrasive material
英 [əˈbreɪsɪv məˈtɪəriəl]
美 [əˈbreɪsɪv məˈtɪriəl]
磨料
英英释义
noun
双语例句
- On the basis of the characteristics of the lubrication film, surface texture, abrasive particle material and work conditions, it sets up the wear rate analysis calculation formula of piston ring and cylinder liner.
本文在考虑了油膜特性、形貌特性、磨粒特性、材料特性及工况条件等因素的基础上，导出了活塞环&缸套的三体磨粒磨损分析计算公式。 - This product is dry powder in the dry cleaning detergent softener can also can be used as abrasive material and emulsion stabilizer SC.
本品干粉在干洗清洁剂中可做软化剂，还可以作为研磨材料的悬浮剂和乳胶稳定剂。 - The wear mechanism of the friction pair involved abrasive wear and material loss on surface layer resulted from UHMWPE plastic deformation.
摩擦副的主要磨损机理为磨粒磨损及UHMWPE塑变导致的表层材料损失。 - Advantages and disadvantages of various methods were analyzed, and technical indexes of superhard abrasive material after treatment were summarized.
分析了各种方法的优缺点，并总结了处理后的技术指标。 - Some measures to accelerate vegetation restoration are proposed in accordance with the regulation on vegetation succession and characteristics of abrasive material.
针对植被演替规律和剥离物特性提出快速恢复植被相应对策。 - According to the working condition of high temperature and abrasive wear, the material structure and composition of the wear-resistant and heat-resistant steel are designed.
根据在高温氧化性气氛下磨料磨损的工况条件，合理设计了抗磨耐热钢材料的组织和化学成分。 - Abrasive material used for on-site surface pretreatment of pipeline corrosion protection joint
管道防腐补口现场表面预处理用磨料 - With the orthogonal tests the influence of work condition of the 3-phase abrasive water jet to material removal and erosion depth is analyzed, and the relationship between the abrasive granularity and the surface roughness is discussed.
通过正交试验，分析了三相射流工作条件对材料去除量和冲蚀深度的影响，讨论了磨料粒度与加工表面粗糙度的关系。 - The machine can improve work efficiency and reduce cost by using the three-phase abrasive material ( gas-liquid-solid) to clean rust and painting with non-air high pressure.
该设备采用了气、液、固三相磨料水射流除锈和无空气高压喷涂技术，大大提高了工作效率，降低了成本。 - In terms of pre concentration strengthening, more crushing and less grinding, abrasive resistant material usage and classification intensification, the paper describes the present situation of grinding classification both in and outside China and discusses on the development orientation of grinding classification in China's metallurgical mines.
本文从强化预选、多碎少磨、应用耐磨材料和强化分级三个方面论述了国内外磨矿分级的现状，探讨了我国冶金矿山磨矿分级的发展方向。